Cellulose and fiberglass loose fill
Blown-In Insulation in Brooklyn, NY
The cost-effective way to add depth over a sealed ceiling or fill a closed frame wall.
- Free on-site estimates anywhere in Brooklyn
- Written quote naming foam type, thickness and R-value for each area
- Leaks, damp masonry and old wiring flagged before anything is covered
When Loose Fill Beats Foam
Blown-in insulation is loose cellulose or fiberglass blown through a hose into attics, cocklofts and wall cavities. It does not stop air on its own the way spray foam does, but over a well-sealed ceiling it adds R-value at a lower cost per square foot. In Brooklyn it fits best in the full attics of frame houses, in cocklofts deep enough to hold it with room for air above, and in closed frame walls as dense-pack.
Seal first, then blow
Loose fill slows heat, but air can still move through it. If warm air is leaking into the attic around light fixtures, chimney chases and plumbing stacks, it carries heat right through the new insulation. So every blown-in job we do starts with air sealing: foam, caulk and fire-rated sealant around every hole in the ceiling plane. Then the loose fill goes on top to depth.
How much is enough
The 2025 NYC Energy Conservation Code lists R-49 at the ceiling for Climate Zone 4A. Loose fill gives less R-value per inch than closed-cell foam, so reaching R-49 takes real depth, often more than a foot depending on the product. Many older Brooklyn attics have only a few inches of old rock wool or fiberglass, compressed and dusty. We measure what is there and blow enough to reach the target.
Cellulose or fiberglass
Cellulose is made mostly from recycled paper treated with fire retardant. It is denser, fills around obstacles well, and is the usual choice for dense-packing walls. Fiberglass is lighter, does not absorb water, and is less dusty to install. Fixr lists blown fiberglass at $1.65 to $2.60 per square foot and cellulose at $1.75 to $3.80. We recommend one or the other based on the space.
Dense-pack in frame walls
In closed wood-frame walls, we drill small holes, blow cellulose in at high density so it fills the cavity and will not settle, and patch the holes. This works in many Flatbush, Ditmas Park, Midwood, Greenpoint and Bushwick frame houses. It does not work in solid brick or brownstone walls, which have no cavity to fill.
Cockloft limits
Many rowhouse cocklofts are too shallow for deep loose fill while keeping vent space above it. Where there is enough room, blowing cellulose over a sealed ceiling is the cheapest way to insulate a flat-roofed house. Where there is not, closed-cell foam on the roof deck may be the better plan.
Tell us what space you want to insulate and how you reach it. We will check depth and access and send a written price. Get a free estimate
Where We Blow In Insulation
The most common blown-in jobs in Brooklyn homes.
Open attics
Cellulose or fiberglass blown to depth over a sealed attic floor in frame houses.
Deeper cocklofts
Loose fill over the top floor ceiling where the cockloft has room for it and air above.
Dense-pack walls
Cellulose blown tightly into closed frame walls through small holes.
Top-ups over old insulation
Adding depth on top of thin, dry existing insulation.

Published Blown-In Insulation Costs
| Job | Range and source |
|---|---|
| Blown-in, per sq ft | $1.00 to $2.80 (HomeGuide); $1.65 to $3.80 (Fixr) |
| Attic | $900 to $3,600 (HomeGuide); $1,750 to $5,500 for about 1,500 sq ft (Fixr) |
| Exterior walls | $1,900 to $7,800 (HomeGuide); $2,000 to $4,000 (Fixr) |
| Dense-pack cellulose | $1.60 to $4.20 per sq ft (HomeGuide) |
| Fiberglass / cellulose | $1.65 to $2.60 / $1.75 to $3.80 per sq ft (Fixr) |
| Typical job | $800 to $3,000 (HomeGuide); $3,000 to $7,000 (Fixr) |
National numbers from HomeGuide (Nov 2025) and Fixr (Aug 2025). Depth, access, air sealing and any removal change the total. The price is the one on the written estimate we give you after the visit.
How a Blown-In Job Runs
1. Measure
We check existing depth, condition, access and the air leaks in the ceiling.
2. Quote
Material, depth, target R-value and air sealing are listed and priced.
3. Seal
We close the leaks in the ceiling plane and baffle vents where needed.
4. Blow and check
Insulation goes in to depth, and we mark and confirm it.

Why Choose Us for Blown-In Insulation
Sealing is included
We do not blow insulation over open air leaks.
Depth you can check
We mark depth in the attic so you can see what you paid for.
Blown-In Insulation Questions
Is blown-in insulation as good as spray foam?
Over a sealed attic floor, it does the job well for less money. It does not seal air itself, which is why we seal first. Under flat roofs with little space, foam often works better.
Does blown-in insulation settle?
Loose fill in an attic settles a little over time, so we install enough to allow for it. Dense-pack in walls is blown tight enough that it does not settle.
Can you blow insulation over what I already have?
If the old insulation is dry and clean, yes. If it is wet, moldy or full of droppings, it should come out first.
Which is better in Brooklyn, cellulose or fiberglass?
Both work. Cellulose is denser and better for dense-pack walls; fiberglass is lighter and shrugs off moisture. We recommend one based on the space.

Blown-In Insulation Service Areas
- Spray Foam Insulation in Brooklyn, NY
- Spray Foam Insulation in Park Slope, NY
- Spray Foam Insulation in Brooklyn Heights, NY
- Spray Foam Insulation in Williamsburg, NY
- Spray Foam Insulation in Greenpoint, NY
- Spray Foam Insulation in Bushwick, NY
- Spray Foam Insulation in Bedford–Stuyvesant, NY
- Spray Foam Insulation in Crown Heights, NY
- Spray Foam Insulation in Flatbush, NY
- Spray Foam Insulation in Ditmas Park, NY
- Spray Foam Insulation in Midwood, NY
- Spray Foam Insulation in Sunset Park, NY
- Spray Foam Insulation in Bay Ridge, NY
- Spray Foam Insulation in Dyker Heights, NY
- Spray Foam Insulation in Bensonhurst, NY
- Spray Foam Insulation in Sheepshead Bay, NY
- Spray Foam Insulation in Gerritsen Beach, NY
- Spray Foam Insulation in Canarsie, NY
- Spray Foam Insulation in Red Hook, NY
Get a Blown-In Insulation Estimate
Tell us the space and how you get to it. We will send a written price.